Complete toolhead including the extruder, hot end, bed probe and fans. Drop in replacement for the existing one. It can also be used on SV06.
SV06 Plus uses a unique hot end design. The original hot end kit replacement comes with an 0.4 nozzle and a silicone sock
Uses non-standard high flow nozzles. They look similar to Volcano nozzles but with different dimensions:
Similar nozzles from Creativity and Polisi3D exist. They are 23mm long and the 0.5mm difference shouldn't be that significant.
SV06 Plus uses a unique hotend design. The original hotend kit replacement comes with an 0.4 nozzle and a silicone sock
|XH 1.25mm 2-Pin
Identical to the one used in Ender S1 Pro.
This is a Creality screen but with Sovol's firmware.
PEI Print Sheet¶
SV06 Plus PEI has a slightly unique design with divots for alignment screws and unusual 320x310mm dimensions. Its painted grid isn't as bad as the SV06 one and doesn't stick to prints.
PEI sheets for Ender 3 S1 Plus and Creality CR10 V2 have the two divots but are 310x315mm.
A standard 310x310 spring steel sheet can work on an SV06 Plus but you'll need to be more careful when placing it.
Heated bed with applied insulation, magnetic sticker and cable with all connectors and crimped ends.
Uses a standard Creality screen but with Sovol's firmware. Original replacement not available yet.
A 24V 500W power supply.
SV06 original mainboard.
LM10UU linear bearings. IKO and Misumi are good quality brands.
There are 11 bearings in total, 3 on the X-axis, Z-axis has 4 and 4 more on the Y-axis.
You can change from linear ball bearings to Igus or Drylin bearings.
Hardened steel 10mm diameter linear rods.
NEMA17 42-34 1.3A 1.8° D5, shaft length 24mm, 42BYGH160-A-20DN from Shengyang Motors
NEMA17 42-40 1.2A 1.8° D5, shaft length 24mm, 42D21C412-02 from dgjlmotor.com
NEMA17 42-34 0.8A 1.8° D5, shaft length 24mm, 42BYGH160-A-20DN from Shengyang Motors
NEMA17 42-23 stepper motor (double output with gear).