Firmware
How to Flash Firmware¶
Troubleshooting steps if you cannot flash the new firmware:
- firmware file is the only file on the SD Card
- rename the firmware file to something unique
- change extension to
.BIN(capital letters) - make sure the SD Card is less than 16Gb and formatted as FAT32 4096 blocks
Marlin¶
Sovol Firmware¶
Original Sovol firmware
hillsoftware's build¶
Custom Sovol SV06 build with options for UBL, Bi-Linear, Manual Mesh, Input Shaping, and X-Twist
blastrock's build¶
This is an attempt at cleaning up branches from various other firmwares while providing a working Marlin 2.1.2 firmware with X-Twist compensation support.
TH3D Unified 2 Firmware¶
https://support.th3dstudio.com/helpcenter/sovol-sv06-firmware/
Klipper¶
One-Stop-Shop Klipper Configuration¶
A comprehensive Klipper configuration for multiple variants of the Sovol SV06.
Supports¶
Sovol Klipper Screen¶
Sovol original touch screen with Klipper preinstalled, like the one used in Sovol SV07.
Buy from
Pr20100+ Klipper profile¶
Complete Klipper profile with all config files and macros to tune the Sovol SV06 (stock).
https://github.com/Pr20100/SOVOL-SV06-Klipper-profile
spinixguy's build¶
https://github.com/spinixguy/Sovol-SV06-firmware
Enable Buzzer Macro¶
Want to use the beeper (M300) G-Code to alert you?
Add this to your macros in Klipper:
######################################################################
# Beeper
######################################################################
# M300 : Play tone. Beeper support, as commonly found on usual LCD
# displays (i.e. RepRapDiscount 2004 Smart Controller, RepRapDiscount
# 12864 Full Graphic). This defines a custom I/O pin and a custom
# GCODE macro. Usage:
# M300 [P<ms>] [S<Hz>]
# P is the tone duration, S the tone frequency.
# The frequency won't be pitch perfect.
[output_pin BEEPER_pin]
pin: PC6
# Beeper pin. This parameter must be provided.
# ar37 is the default RAMPS/MKS pin.
pwm: True
# A piezo beeper needs a PWM signal, a DC buzzer doesn't.
value: 0
# Silent at power on, set to 1 if active low.
shutdown_value: 0
# Disable at emergency shutdown (no PWM would be available anyway).
cycle_time: 0.001
# Default PWM frequency : 0.001 = 1ms will give a tone of 1kHz
# Although not pitch perfect.
[gcode_macro M300]
gcode:
# Use a default 1kHz tone if S is omitted.
{% set S = params.S|default(1000)|int %}
# Use a 10ms duration is P is omitted.
{% set P = params.P|default(100)|int %}
SET_PIN PIN=BEEPER_pin VALUE=0.5 CYCLE_TIME={ 1.0/S if S > 0 else 1 }
G4 P{P}
SET_PIN PIN=BEEPER_pin VALUE=0
Borrowed from: https://dev.to/wallclocks/enable-buzzer-in-klipper-for-creality-boards-422-427-19mg
Guided filament change macro¶
https://www.reddit.com/r/klippers/comments/m57iai/mom_my_overpowered_m600_command/
Home Assistant Integration¶
https://github.com/fryc88/HomeAssistant-Moonraker-for-Klipper